Paragon Viking Water Cooled Shirt Complete

Paragon water cooling systems circulate ice water around the driver to lower and stabilize core body temperatures. The 18 L Liter Viking system provides up to 6 hours of cooling from a single block of ice, or about 3 hours using cubed ice.

• 18L Cooler
• 4ft Hose
• Mounting Tray
• White Shirt with Right Side Exit
• Universal Drain
• Defense Solution

The leakproof Viking Series cooler measures 17" long x 11" wide x 14" high. The hinges and latches on the cooler lid can be reversed to allow for the most efficient routing of the hose outlets and easiest access for refilling. The internal 2 amp pump is designed to be wired directly to a 12 volt power supply.

Paragon water cooling shirts feature a HANS-friendly design that routes the water tubing away from the driver's shoulders. Conventional designs run the tubing over the driver's shoulders, sometimes causing uncomfortable interference with shoulder harnesses.

This white shirt is compatible with all Paragon brand water-circulating driver cooling systems as well as older Cool Shirt brand systems. Cotton is recommended for water-cooled systems because it is the best fabric at transferring body heat. These shirts are made of 100% preshrunk cotton, so you never have to worry about the size changing.

Available in T-shirt sizes Small through XX-Large, with the 24" long hoses exiting on the right side of the shirt.

Guardian insulated hoses from Paragon are designed to work with all Paragon brand water-circulating driver cooling systems. They are also backwards-compatible with Cool Shirt brand systems.

This hose set consists of an 4 foot long paired insulated 5/16" ID hose set with male connectors installed at one end and female connectors installed at the other end. One hose kit is enough to connect one shirt to a cooler. This long hose set is primarily intended for installations where the cooler is located in the far corner of the cockpit from the driver.

Insulation color may vary from photo. Sorry, no color choice

his powdercoated aluminum tray is designed to make it easy to mount your Paragon brand 18-Liter Viking cooler. Simply fasten the tray to your chassis (mounting hardware not included) and secure the cooler to the tray using the two included nylon restraint straps. The innovative dual-strap design of the Paragon coolers lets you open the cooler to load ice and water without undoing the straps.

The quick-disconnect fittings in Paragon water-circulating driver cooling systems automatically close when disconnected in order to trap the water inside. The only downside is that you don't want that water sitting in the system between races. You need a way to open the connectors to drain the water out!

This kit makes it easy to drain the water from your Paragon Viking series cooler, hoses, and shirt for storage. Simply connect the fittings in the kit to the fittings in your Paragon driver cooling system and let the water drain out. Includes two male and two female connectors.

Keep the water hoses in your water-circulating driver cooling system clean and free of algae! Simply add 2 ounces of Defense Solution to the ice water in the cooler each time you use your system. No more flushing your shirt with alcohol to remove the green stuff. Non-toxic, biodegradable, environmentally-friendly Defense Solution also lubricates and protects the pump for longer system life. Suitable for use with other brands, too. 16 ounce bottle is enough for 8 uses.